Australian load cell

P/N: 200_06_LCSA

Download PDF

The Cadex Australian load cell kit is used to determine the ability of a protective helmet to distribute the force of an impact as per AS/NZS 2512.9.


  • Two headforms (radius 60 & 70 mm) with built-in load cell included
  • Dedicated falling anvil included
  • Mini MEP pad included (to perform “repeatability” system check)
  • Compatible with the Cadex software

Dimensions (Approx.):

  • Length: 20.32 cm / 8 in
  • Width: 27.94 cm / 11 in
  • Height: 22.86 cm / 9 in (without headform)
Shown installed on twinwire machine
Shown installed on twinwire machine
Compatible with Cadex Software.
Compatible with Cadex Software.
Please check to be sure that all information is complete and correct to the best of your knowledge.

This site is registered on as a development site.